RetroScaler RGBS YPbPr Upscaler 1080P HDMI Converter Adapter For Classic PS1 PS One Fat PS2 And Slim PS2 Game Console
INTRODUCTION
RetroScaler RGBS/YPbPr Upscaler is an HD converter specially designed for PS1 and PS2 game console. With a simple "plug and play" method, It is possible to connect your PS1 or PS2 game console to a TV's HDMI interface with HD image quality.
Moreover, It has RGBS/YPBPR switch that make full compatible with PS1/PS2 game consoles and also has 16:9/4:3 game aspect ratio switch, which bringing you a better gaming experience.
FEATURES
1) Converts the analog RGBS signal and Component signal to digital 1080P HDMI which output for modern HD TVs, monitors and projectors.
2) Supports all version of the classic PS1, PS One, Fat PS2 and Slim PS2.
–Caution: PS1 consoles only output the RGBS signal.
PS2 consoles can output the RGBS andYPbPr signal.
3) Built in RGB / YPbPr switch and 16:9 / 4:3aspect ratio switch.
– Be surethe mode (RGBS/YPbPr) you are switchingshould be consistent with the mode was set by your PS2 console.
4) Support input resolutions:
For YPbPr - 240p, 288p, 480i, 480p, 576i, 576p, 720p, 1080i.
For RGBS - 240P, 288P, 480P, 480i, 576P, 576i.
5) Output Mode: 1080P HDMI.
6) Easy to use with well-prepared cables included. (Micro USB cable and the HDMI cable).
SPECIFICATION
• Device Dimensions: 7.5cm W: 4.5cm H: 1.5cm
• Cable Length:23cm
• Weight: 46g
• Power Consumption: 5V/1A
OPERATION INSTRUCTION
1) Remove the previousA/Vof PS1/PS2cable and connect RetroScaler1080P upscaler.
2) Plug one end of your HDMI cable into the RetroScaler1080P upscaler, and the other end intoa free HDMI socket on your TV.
3) On the PS1 console, please select the ‘RGB’mode on the RetroScaler 1080P upscaler.
4) On the PS2 console, please select the ‘RGB’or‘YPbPr’mode on the adapter to fit your PS2 console setting. To assure the absolute best possible image output, ifyou experience any green screens or distorted images during the configuration of PS2, it is likely the RGB setting or Component settings are selected with the incorrect output in the PS2 configuration menu.
As described and shown below, visit the PS2 configuration menu and change the Component Video Out setting to YCb/Pb Cr/Pr. And changethe slider on the PS2 HDMI adapter to YPbPr.
An example of the setting to change is shown below:
4) Power on your PS1/PS2 and TV. Connect to micro-USB 5V power supply. Make sure your TV’s has been switched to the correct HDMI input where the Retroscaler 1080p upscaler is connected.
5) Verify that you can see the PS1/PS2 picture on your TV.
FAQ
Q1： Is this GSM compatible?
A1: Yes, It compatible GSM.
