This is a LED Arcade Game DIY Parts for 2 Player DIY Project.
The encoder support all the windows systems!
All the buttons are not metal.
If the LED does not light. Then please exchange the location LED interface.
Each player has its own USB cable to make sure that Multiplayer can play the games in the same condition!
The Joystick is a 8 way professional joystick!
The buttons are 5V Full Colors LED Illuminated push buttons with build-in Microswitches inside.
The default buttons as lighted all the time.
If you purchase one of this items, what will included in the package
2x Zero Delay LED USB Encoder
2x USB Cable
2x 5Pin wires for Joystick
19x 3Pin wires for LED Push Buttons
1x Red 5Pin 8 way joystick
1x Blue 5Pin 8 way joystick
1x 1 Player 30MM 5V LED Push Buttons (White) With LED Lamp and Micro Switch
1x 2 Player 30MM 5V LED Push Buttons (White) With LED Lamp and Micro Switch
2x Coin 30MM 5V LED Push Buttons (White) With LED Lamp and Micro Switch
16x 30MM 5V LED Push Buttons With LED and Micro Switch (4x Red 4x Yellow 4x Green 4x Blue)
1x Instructions
Button wiring method
Please note:
LEDs distinguish between positive and negative.
If the LED is not lit. Please replace the LED cable interface location.
However, pay attention to the direction of the LEDs. When connected, I inverted 75% of the LEDs that were installed upside down.
Everything is fine by removing them and turning them over.
Joystick
|
|
|
|
|---|---|---|
Can replace the different bal
|
Joystick bottom
|
Specification map
|
Push Buttons
|
|
|
|
|---|---|---|
1 Player 2 Player + 2x Coin Buttons
|
|
|
USB Controllers
|
|
|
|
|---|---|---|
USB Encoder
|
Button wiring
|
PCB Board
|
